AREA OF USAGE
- Damp (Rising, Penetrating and Condensation)
- Mould Manifestation
- Salt Contamination
- Fractured Plastering
- Discolored Walls
- Peeling Paint and Wallpaper
- Fungal Decay
- Prevents Thermal Heat Loss
KEY BENEFITS
- Resists the attack of salts like chlorides and sulphates that are present in the soil.
- Easy to apply
- Cold applied
- Adheres to concrete
- Can be applied in closed or confined spaces
- Non-flammable
- Versatile
- Economical
Colour: Black | Roll
Packaging: Available in 225mm width & 32 ft. Length. | Thickness 1.5 mm.
Coverage : As per roll length
Shelf Life : 12 Months from the date of manufacture when maintain in protected storage in original unopened sealed condition.
Storage Conditions
Store under cover out of direct sunlight and protect from extremes of temperature. In tropical climates the product must be stored in an airconditioned environment. Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging.
SURFACE PREPARATION
The surface shall be cleaned thoroughly of all contaminants like dust, traces of curing compound, oil and grease. All surface imperfections and protrusions are to be removed and repaired. Structurally unsound and friable concrete must be removed and repaired with a suitable repair mortar or PMM.
PRIMING
Primer is always recommended prior to coating as it not only penetrates into the concrete pores and seals the substrate. It also acts as an adhesion promoter for
further coatings. It is advised to use TT Bitumen Primer. The primer may be applied by a brush, roller or airless spray. Allow the primer to dry before any further coats are applied. However, if the primer after application is left open for more than 24 hours after it becomes dry, clean the surface of any settled dust and apply a fresh coat of the primer.
Note : The application temperature should be between 5°C to 55°C. Application procedures may vary slightly depending upon site conditions.
DPC Membranes are best installed in new construction. Our Membrane can be installed within, brick, stone and concrete walls. They are suitable for use as a vertical DPC as well as in horrizontal application. They are not suitable above lintels or spanning across cavity walls. The DPC membrane must be installed 150mm. above the ground level. Peel the release film stick the membrane properly on the surface.
